![]() If you are using the Hubsan x4/Ladybird motors, clockwise are Blue (GND) / Red (VCC) wires, anticlockwise It is therefore simplest to wire the motors: In standard QUADX configuration, the motors are mapped: Cleanflight USART1 (along with power) is on the following pins. A regulated 3.3v supply can be found on the top pin of column 1, just below the RX GND pin. Be careful if you are using a voltage sensitive RX. NOTE: The VCC RX Pin is not regulated and will supply what ever voltage is provided to the board, this will mean it'll provide 5v if a 5v serial connection is used. ![]() Version 2 boards are supported from firmware v1.4.0 onwards, do NOT flash earlier versions to version 2 boards. ![]() Uses blue and red LEDsīoot jumper pads presoldered with pins and a jumper by LED1. This board does not have an onboard USB-Serial converter, so an external adapter is needed. The CJMCU is a tiny (80mm) board running a STM32F103, which contains a 3-Axis Compass (HMC5883L)
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |